Show Ip Igmp Groups - Dell C9000 Series Reference Manual

Defaults 2 (that is, IGMPv2)
Command Modes
INTERFACE
INTERFACE (BATCH Mode)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.5(0.0)
9.0.2.0
9.2(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.5.1.0

show ip igmp groups

View the IGMP groups.
C9000 Series
Syntax
show ip igmp groups [group-address [detail] | detail | interface
[group-address [detail]]]
Parameters
group-address
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON. Changed the default IGMP from
version 2 to version 3.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the group address in dotted decimal format
to view information on that group only.
Internet Group Management Protocol (IGMP) 1137