Lsp-Gen-Interval - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage Information This command allows you to monitor adjacency state changes, which are useful when
you monitor large networks. Messages are logged in the system's error message facility.

lsp-gen-interval

Set the minimum interval between successive generations of link-state packets (LSPs).
C9000 Series
Syntax
lsp-gen-interval [level-l | level-2] interval seconds
[initial_wait_interval seconds [second_wait_interval seconds]]
To restore default values, use the no lsp-gen-interval [level-l | level-2]
interval seconds [initial_wait_interval seconds
[second_wait_interval seconds]] command.
Parameters
level-l
level-2
interval seconds
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
(OPTIONAL) Enter the keywords level-1 to apply the
configuration to generation of Level-1 LSPs.
(OPTIONAL) Enter the keywords level-2 to apply the
configuration to generation of Level-2 LSPs.
Enter the maximum number of seconds between LSP
generations. The range is from 0 to 120 seconds. The default is 5
seconds.
Intermediate System to Intermediate System (IS-IS) 1087