Dell C9000 Series Reference Manual page 933

Version
7.6.1.0
7.5.1.0
6.4.1.0
Usage Information You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP
address or switchport. To place an interface in Layer 2 mode, ensure that the interface's
configuration does not contain an IP address and enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface
with no default configuration. To delete a tunnel interface, use the no interface
tunnel tunnel-id command.
Example
Dell(conf)# int tengigabitethernet 0/0
Dell(conf-if-te-0/0)#exit
Dell(conf)#
Example peGigE
Dell#show interfaces peGigE 0/0/0
peGigE 0/0/1 is up, line protocol is up
Hardware is DellEth, address is a0:68:00:3f:92:bd
Pluggable media not present
Interface index is 536870919
Internet address is not set
Mode of IPv4 Address Assignment : NONE
DHCP Client-ID :a068003f92bd
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 1000 Mbit, Mode full duplex
Auto-mdix enabled, ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 02:44:11
Queueing strategy: fifo
Input Statistics:
pkts
1023-byte pkts
Output Statistics:
pkts
pkts
Rate info (interval 299 seconds):
line-rate
line-rate
Description
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
Current address is a0:68:00:3f:92:bd
5150004 packets, 4996095648 bytes
164432 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte
0 over 255-byte pkts, 4985572 over 511-byte pkts, 0 over
0 Multicasts, 0 Broadcasts, 5150004 Unicasts
0 runts, 0 giants, 0 throttles
0 CRC, 0 overrun, 0 discarded
11165065 packets, 714564160 bytes, 0 underruns
11165065 64-byte pkts, 0 over 64-byte pkts, 0 over 127-byte
0 over 255-byte pkts, 0 over 511-byte pkts, 0 over 1023-byte
309 Multicasts, 0 Broadcasts, 11164756 Unicasts
0 throttles, 0 discarded, 0 collisions, 0 wreddrops
Input 140.00 Mbits/sec,
Output 20.00 Mbits/sec,
18070 packets/sec, 14.30% of
39175 packets/sec, 2.60% of
Interfaces 933