Reset - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Example
Dell# pe 255 stack-unit 0 renumber 2

reset

Reset or reboot the linecard, RPM, PE and PE stack-unit.
C9000 Series
Syntax
reset {linecard slot-id | rpm slot id [hard] | pe pe-id [stack-unit
unit-number]}
From a PE console, use reset stack-unit unit-number [hard] to reset the stack-unit.
Parameters
linecard slot-id
rpm
hard
pe pe-id
stack-unit unit-
number
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Enter the keyword linecard and the slot-id number to specify the set
of line-card ports for reset. The slot ID range is from 0 to 11.
Enter the keyword rpm and the slot-id number to specify the route
processor module (RPM) ports for reset. The range for the RPM card
ports is from 0 to 1.
(Optional) Reboot (power cycle) the specified line card, RPM card, or PE
stack-unit (The hard option for PE is only available from PE console).
Enter the keyword pe and the port extender (PE) ID. The range for pe-id
is from 0 to 255.
(Optional) Enter the keyword stack-unit and the stack-unit number.
The range is from 0 to 7.
PE Stacking 1628