Power Inline Mode - Dell C9000 Series Reference Manual

Example
Dell(conf)#power inline legacy pe 0 stack-unit 0

power inline mode

Configures PoE power management mode for a specified port extender.
C9000 Series
Syntax
power inline mode {pe pe-id stack-unit unit number class |
static }
Parameters
pe pe-id
stack-unit unit
number
class
static
Defaults Static
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
Usage Information The power inline mode command allows you to manage inline power supply on
the port extender (PE) ports. You can configure class or static mode to manage
inline power in a port extender.
When class mode is configured, maximum power for the particular class of device is
allocated. Class mode supports power allocation via Layer 2 classification and power
negotiation by Link Layer Discovery Protocol (LLDP) 802.3at standard . When static
mode is configured, the inline power is allocated based on the actual power
Enter the keyword pe and port extender ID. Range is 0–255.
Enter the keyword stack-unit and the unit number. Range is
0–7.
Enter the keyword class to configure the class mode for the
specified port extender.
Enter the keyword static to configure the static mode for the
specified port extender.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Port Extenders (PE) 1755