Interface Loopback - Dell C9000 Series Reference Manual

Time since last interface status change: 02:37:06
Related show interfaces
Commands

interface loopback

Configure a Loopback interface.
C9000 Series
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
Parameters
number
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Example
Dell(conf)# interface loopback 1655
Dell(conf-if-lo-1655)#
— displays the interface configuration.
Enter a number as the interface number. The range is from 0 to
16383.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
Interfaces 934