Gvrp Enable - Dell C9000 Series Reference Manual

Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
Usage Information
Related show garp timers
Commands

gvrp enable

Enable GVRP on physical interfaces and LAGs.
C9000 Series
Syntax
gvrp enable
To disable GVRP on the interface, use the no gvrp enable command.
Defaults Disabled.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
• Join Timer — Join messages announce the willingness to register some
attributes with other participants. For reliability, each GARP application entity
sends a Join message twice and uses a join timer to set the sending interval.
• Leave Timer — Leave announces the willingness to de-register with other
participants. Together with Join, Leave messages help GARP participants
complete attribute reregistration and de-registration. The leave timer starts after
receipt of a leave message sent for de-registering some attribute information. If a
Join message is not received before the Leave time expires, the GARP
application entity removes the attribute information as requested.
• Leave All Timer — The Leave All timer starts when a GARP application entity
starts. When this timer expires, the entity sends a Leave-all message so that
other entities can reregister their attribute information. Then the Leave-all time
begins again.
— displays the current GARP times.
GARP VLAN Registration (GVRP) 900