Dell C9000 Series Reference Manual page 1690

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Command Modes

Command History

This guide is platform-specific. For command information about other platforms, see

the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information The following describes the show ip pim interface command shown in the

following example.

EXEC Privilege

Introduced on the C9010.

Introduced on the Z9500.

Introduced on the S6000.

Introduced on the S4820T.

Introduced on the S4810.

Introduced on the Z9000.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Lists the IP addresses of the interfaces participating in PIM.

List the interface type, with either slot/port information or ID

(VLAN or Port Channel), of the interfaces participating in PIM.

Displays the PIM version number and mode for each interface

participating in PIM:

v2 = PIM version 2

S = PIM Sparse mode

Displays the number of PIM neighbors discovered over this

Displays the query interval for Router Query messages on that

interface (configured with ip pim query-interval

Displays the Designated Router priority value configured on the

interface (use the ip pim dr-priority command).

Displays the IP address of the Designated Router for that

PIM-Sparse Mode (PIM-SM)

Chapters

Table of Contents