Isis Network Point-To-Point - Dell C9000 Series Reference Manual

level-1
level-2
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage Information Dell Networking recommends configuring metrics on all interfaces. Without
configuring this command, the IS-IS metrics are similar to hop-count metrics.

isis network point-to-point

Enable the software to treat a broadcast interface as a point-to-point interface.
C9000 Series
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
Defaults Not enabled.
Command Modes INTERFACE
(OPTIONAL) Enter the keywords level-1 to configure the
shortest path first (SPF) calculation for Level 1 (intra-area)
routing. This setting is the default.
(OPTIONAL) Enter the keywords level-2 to configure the SPF
calculation for Level 2 (inter-area) routing.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Intermediate System to Intermediate System (IS-IS) 1082