Interface Vlan - Dell C9000 Series Reference Manual

Related
Commands

interface vlan

Configure a VLAN. You can configure up to 4094 VLANs.
C9000 Series
Syntax
interface vlan vlan-id
Parameters
vlan-id
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command Modes CONFIGURATION
Command History
Version
9.9(0.0)
9.0(1.3)
Usage Information For more information about VLANs and the commands to configure them, refer to the
Virtual LAN (VLAN) Commands
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs are not
supported in VLANs. IP ACLs are supported. For more information, refer to the
Access Control Lists (ACL)
Example (Single
Dell(conf)# int vlan 3
Range)
Dell(conf-if-vl-3)#
Related
Commands
• interface range — configures a range of command (bulk configuration).
• interface range macro (define)
configuration).
Enter a number as the VLAN Identifier. The range is 1 to 4094.
Description
Introduced on the C9010.
Introduced on the S5000.
• interface – configures a physical interface.
• interface loopback – configures a loopback interface.
• interface null – configures a null interface.
• interface port-channel
• show vlan – displays the current VLAN configuration on the switch.
• shutdown – disables/enables the VLAN.
• tagged – adds a Layer 2 interface to a VLAN as a tagged interface.
• untagged – adds a Layer 2 interface to a VLAN as an untagged interface.
— defines a macro for an interface range (bulk
section of the Layer 2
chapter.
– configures a port channel group.
chapter.
Interfaces 943