Dell C9000 Series Reference Manual page 1116

vrf vrf-name
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
Usage Information Use this command to confirm that the neighbor adjacencies are operating correctly. If
you suspect that they are not, you can verify the specified area addresses of the routers
by using the show isis neighbors command.
The following describes the show isis neighbors command shown in the following
example.
Field
System Id
Interface
State
Type
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
(OPTIONAL) Enter the keyword vrffollowed by the name of the
VRF to display adjacent router information corresponding to that
VRF
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Description
The value that identifies a system in an area.
The interface, slot, and port in which the router was discovered.
The value providing status about the adjacency state. The range
is Up and Init.
This value displays the adjacency type (Layer 2, Layer 2 or both).
Intermediate System to Intermediate System (IS-IS) 1116