Show Ip Flow - Dell C9000 Series Reference Manual

show ip flow

Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
C9000 Series
Syntax
show ip flow interface interface {source-ip address destination-ip
address} {protocol number [tcp | udp]} {src-port number
destination-port number}
Parameters
interface interface
source-ip address
destination-ip
address
protocol number
[tcp | udp]
src-port number
destination-port
number
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
Enter the keyword interface then one of the following interface
keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keywords source-ip then the IP source address in IP
address format.
Enter the keywords destination-ip then the IP destination
address in IP address format.
Enter the keyword protocol then one of the protocol type
keywords: tcp, udp, or protocol number The protocol
number range is from 0 to 255. .
Enter the keywords src-port then the source port number.
Enter the keywords destination-port then the destination
port number.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
IPv4 Routing 1218