Clear Ip Msdp Sa-Cache - Dell C9000 Series Reference Manual

Parameters
peer address
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.5(0.1)
8.3.19.0
8.3.11.1
8.3.7.1
6.2.1.1

clear ip msdp sa-cache

Clears the entire source-active cache, the source-active entries of a particular multicast group, rejected, or
local source-active entries.
C9000 Series
Syntax
clear ip msdp sa-cache [group-address | rejected-sa | local]
Parameters
group-address
rejected-sa
local
Defaults Without any options, this command clears the entire source-active cache.
Command Modes EXEC Privilege
Enter the peer address in a dotted decimal format (A.B.C.D.)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced
Enter the group IP address in dotted decimal format (A.B.C.D.).
Enter the keywords rejected-sa to clear the cache source-
active entries that are rejected because the RPF check failed, an
SA filter or limit is configured, the RP or MSDP peer is
unreachable, or because of a format error.
Enter the keyword local to clear out local PIM advertised
entries. It applies the redistribute filter (if present) while adding
the local PIM SA entries to the SA cache.
Multicast Source Discovery Protocol (MSDP) 1403