Dell C9000 Series Reference Manual page 1241

ipv4pbr number
iscsioptacl
number
openflow number
vrfv4acl number
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
9.2(0.0)
9.1.(0.0)
8.3.19.0
8.3.12.0
8.3.11.1
8.3.1.0
8.2.1.0
7.8.1.0
Usage Information For the new settings to take effect, save the new CAM settings to the startup-config
(write-mem or copy run start) then reload the system.
Enter ipv4pbr and the FP block number for IPv4 PBR ACL. The
FP block number range is 0 to 6.
Enter iscsioptacl and the FP block number for ISCSI
optimization ACL. The FP block number range is 0 to 6.
Enter openflow and the FP block number for OpenFlow ACL.
The FP block number range is 0 to 6.
Enter vrfv4acl and the FP block number for VRF ACL. The FP
block number range is 0 to 6.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Added support for the fcoe parameter on the S4810 and
S4820T.
Added support for OpenFlow on the Z9000.
Introduced on the S4820T.
Added the keywords fcoeacl and iscsioptacl on the S4810.
Introduced on the Z9000.
Added the keywords ecfmacl, vman-qos, and vman-dual-
qos.
Introduced on the S-Series.
Introduced on the C-Series.
IPv6 Access Control Lists (IPv6 ACLs) 1241