Dell C9000 Series Reference Manual page 953

an untagged member of VLAN 10, which becomes the native VLAN of the port. The
port now accepts:
•
•
The following describes the do show interfaces command shown in the following
example. This example shows output with "Hybrid" as the newly added value for
802.1QTagged. The options for this field are:
•
•
•
The following describes the interface vlan command shown in the following
example. This example shows unconfiguration of the hybrid port using the no
portmode hybrid command.
Example
Dell(conf)# interface te 2/0
Dell(conf-if-te-2/0)# portmode hybrid
Dell(conf-if-te-2/0)# interface vlan 10
Dell(conf-if-vl-10)# untagged te 2/0
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# tagged te 2/0
Dell(conf-if-vl-20)#
Example
Dell(conf-if-vl-20)# do show interfaces switchport
Name: TenGigabitEthernet 2/0
802.1QTagged: Hybrid
Vlan membership:
Vlan
Native
Dell(conf-if-vl-20)#
Example (Vlan)
Dell(conf-if-vl-20)# interface vlan 10
Dell(conf-if-vl-10)# no untagged te 2/0
Dell(conf-if-vl-10)# interface vlan 20
Dell(conf-if-vl-20)# no tagged te 2/0
Dell(conf-if-vl-20)# interface te 2/0
Dell(conf-if-te-2/0)# no portmode hybrid
Dell(conf-if-vl-20)#
Related
•
Commands
•
•
untagged frames and classify them as VLAN 10 frames
VLAN 20 tagged frames
True — port is tagged
False — port is untagged
Hybrid — port accepts both tagged and untagged frames
NOTE: Remove all other configurations on the port before you can remove the
hybrid configuration from the port.
10, Vlan 20
VlanId: 10
show interfaces switchport
interfaces on the switch.
switchport — places the interface in a Layer 2 mode.
vlan-stack trunk — specifies an interface as a trunk port to the Stackable VLAN
network.
— displays the configuration of switchport (Layer 2)
Interfaces 953