Show Interfaces Status - Dell C9000 Series Reference Manual

1000Base-T Status
PHY Extended Control
Example
Related
show interfaces
Commands
interface.

show interfaces status

To display status information on a specific interface only, display a summary of interface information or
specify a line card slot and interface.
C9000 Series
Syntax
show interfaces [interface | linecard slot-number] status
Parameters
interface
Master/Slave Fault
Master/Slave
Local RX OK
Remote RX OK
Link Partner 1G FD
Link Partner 1G HD
Idle Err Cnt
MDI Crossover_mode
— displays information on a specific physical interface or virtual
(OPTIONAL) Enter one of the following keywords and slot/port
or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port (ports or port-
range) information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port (ports or port-range)
information.
• For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
• For a Port-Channel interface, enter the keyword port-
channel then the number. The range is from 0 to 128.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE:
the feature extended bridge is enabled.
: No
: Slave
: False
: False
: False
: False
: 0
: Enabled
The peGigE interface option is only visible when
Interfaces 986