Ip Pim Bsr-Candidate - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Usage Information This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are

cleaned up by time-out. To clean the candidate RP advertisements, use the clear ip

pim rp-mapping command.

ip pim bsr-candidate

To join the Bootstrap election process, configure the PIM router.

C9000 Series

ip pim bsr-candidate interface ][hash-mask-length] [priority]

To return to the default value, use the no ip pim bsr-candidate command.

hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from zero

Not configured.

Introduced on the S4820T.

Introduced on the Z9000.

Introduced on the S4810.

Introduced on the E-Series ExaScale.

Introduced on the S-Series.

Enter the following keywords and slot/port or number

information:

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a Port Channel interface, enter the keywords port-

channel then a number. The range is from 1 to 128.

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a VLAN, enter the keyword vlan then a number from 1

(0) to 32. The default is 30.

(OPTIONAL) Enter the priority used in Bootstrap election

process. The range is from zero (0) to 255. The default is zero

PIM-Sparse Mode (PIM-SM)

Table of Contents