Buffer-Stats-Snapshot - Dell C9000 Series Reference Manual

buffer-stats-snapshot

Enable the buffer statistics tracking utility and enter the Buffer Statistics Snapshot configuration mode. You
must enable this utility to be able to configure the parameters for buffer statistics tracking.
C9000
Syntax
[No] buffer-stats-snapshot
To disable the buffer statistics tracking utility, enter the disable command from the
BUFFER-STATS-SNAPSHOT mode.
Default By default, buffer statistics tracking is disabled.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
Version
9.10(0.0)
9.9(0.0)
9.7(0.0)
9.3.0.0
Usage Information Only the software-based trigger for retrieving and calculating the snapshots of the
statistical counters of the buffer space is supported. Collection of snapshots of buffer
statistical counters based on hardware threshold settings is not supported, which can
be used to specify the type of hardware threshold and the threshold profile templates.
Use this command in Configuration Terminal Batch mode to enable the tracking utility
in a dual-homing setup.
Example
Dell(conf)#buffer-stats-snapshot
Dell(conf-buffer-stats-snapshot)#?
disable
end
exit
configuration mode
no
show
Dell(conf-buffer-stats-snapshot)#no disable
Dell(conf-buffer-stats-snapshot)#show configuration
!
buffer-stats-snapshot
no disable
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the S6000-ON.
Introduced on the S6000 platform
Disable buffer-stats-snapshot globally
Exit from configuration mode
Exit from buffer-stats-snapshot
Negate a command or set its defaults
Show buffer-stats-snapshot configuration
Quality of Service (QoS) 1800