Dell C9000 Series Reference Manual page 1153

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

Command Modes

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Usage Information This command displays the IGMP database, including configured entries for either all

groups on all interfaces, all groups on specific interfaces, or specific groups on specific

The following describes the show ip igmp groups command shown in the following

Group Address

Last Reporter

For a 1-Gigabit Ethernet interface, enter the keyword

GigabitEthernet then the slot/port information.

For a 10-Gigabit Ethernet interface, enter the keyword

TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword

fortyGigE then the slot/port information.

For a Loopback interface, enter the keyword loopback

then a number from 0 to 16383.

For a port channel interface, enter the keywords port-

channel then a number.

For a VLAN interface, enter the keyword vlan then a

number from 1 to 4094.

(OPTIONAL) Enter the keyword detail to display the IGMPv3

source information.

EXEC Privilege

Introduced on the C9010.

Introduced on the S3048-ON and S4048-ON.

Introduced on the S4810, S4820T, S5000, S6000, Z9000, and

Lists the multicast address for the IGMP group.

Lists the interface type, slot and port number.

Displays the IGMP version used.

Displays the amount of time the group has been operational.

Displays the amount of time until the entry expires.

Displays the IP address of the last host to be a member of the

Internet Group Management Protocol (IGMP)

Chapters

Table of Contents