Redundancy Disable-Auto-Reboot - Dell C9000 Series Reference Manual

period minutes
Default
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
8.3.19.0
8.3.12.0
8.1.1.0
7.5.1.0
7.6.1.0
Usage Information If you disable auto failover, enter the redundancy auto-failover-limit (without
any parameters) to set auto failover to the default parameters (Count 3, Period 60
minutes). To view the redundancy status, use the show redundancy command.
When you change one or both of the optional parameters, Dell Networking OS checks
that the interval between auto failovers is more than five (5) minutes. If the interval is
less, Dell Networking OS returns a configuration error message.

redundancy disable-auto-reboot

Prevent the system from auto-rebooting the failed module.
C9000 Series
Syntax
redundancy disable-auto-reboot {linecard [slot—id | all] | pe pe-
id stack unit unit-number | all | rpm}
Enter a duration in which to allow a number of automatic
failovers (limited to the number defined in the count parameter).
The range is from 5 to 9000 minutes. The default is 60 minutes.
• Count: 3
• Period: 60 minutes
Description
Introduced on the C9010.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Introduced on the C-Series.
Introduced on the E-Series
High Availability (HA) 909