Rate Shape - Dell C9000 Series Reference Manual

vlan vlan-id
Defaults Granularity for commited-rate and peak-rate is Mbps unless you use the kbps
option.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.6.1.0
7.5.1.0
6.1.1.1
Usage Information
On one interface, you can configure the rate police command for a VLAN or you
can configure the rate police command for an interface. For each physical
interface, you can configure three rate police commands specifying different
VLANS.
Related
rate-police
Commands

rate shape

Shape the traffic output on the selected interface.
C9000 Series
Syntax
rate shape [kbps] rate [burst-KB]
(OPTIONAL) Enter the keyword vlan then a VLAN ID to police
traffic to those specific VLANs. The range is from 1 to 4094.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the kbps option on the C-Series, E-Series, and S-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: Per Port rate limit and rate police is supported for Layer 2 tagged and
untagged switched traffic and for Layer 3 traffic. Per VLAN rate limit and rate
police is supported on only tagged ports with Layer 2 switched traffic.
— specifies traffic policing on the selected interface.
Quality of Service (QoS) 1797