Ip Address - Dell C9000 Series Reference Manual

Networking command-line reference guide

Hide thumbs Also See for C9000 Series:

Table of Contents

You can activate flow-based monitoring for a monitoring session by entering the flow-

based enable command in the Monitor Session mode. When you enable this

capability, traffic with particular flows that are traversing through the ingress and egress

interfaces are examined and, appropriate ACLs can be applied in both the ingress and

egress direction. Flow-based monitoring conserves bandwidth by monitoring only

specified traffic instead all traffic on the interface. This feature is particularly useful

when looking for malicious traffic. It is available for Layer 2 and Layer 3 ingress and

egress traffic. You may specify traffic using standard or extended access-lists. This

mechanism copies all incoming or outgoing packets on one port and forwards (mirrors)

them to another port. The source port is the monitored port (MD) and the destination

port is the monitoring port (MG).

ip address

Assign a primary and secondary IP address to the interface.

C9000 Series

ip address {ip-address mask [secondary] | dhcp}

To delete an IP address from an interface, use the no ip address [ip-address]

Not configured.

Command Modes

Command History

This guide is platform-specific. For command information about other platforms, refer

to the relevant Dell Networking OS Command Line Reference Guide.

The following is a list of the Dell Networking OS version history for this command.

Enter an IP address in dotted decimal format.

Enter the mask of the IP address in slash prefix format (for

example, /24).

(OPTIONAL) Enter the keyword secondary to designate the IP

address as the secondary address.

Enter the keyword dhcp to configure an interface to receive its

IP address from the configured DHCP server.

Introduced on the C9010.

IPv4 Routing

Table of Contents