Dell C9000 Series Reference Manual page 910

Parameters
lincard slot-id / all
pe pe-id / all
stack unit unit-
number
rpm
Default Disabled (that is, the failed module is automatically rebooted).
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.1.1.0
7.6.1.0
Usage Information Enabling this command keeps the failed module (RPM, PE, or Linecard) in the failed
state. If there are two RPMs or PEs in the system, enabling this command prevents the
failed RPM or PE from becoming a working Standby RPM or PE. If there is only one RPM
or PE in the system, the failed RPM or PE does not recover and affects the system.
Example: PE
Dell(conf)#redundancy disable-auto-reboot pe 1 stack-unit
Enter the keyword linecard with the slot-id to specify a
linecard, or all to select all linecards. Linecard ID. Range is
from 0 to 11.
Enter the keyword pe and the port extender ID or type the
option all to select all port extenders. Range is from 0 to 255.
Enter the keyword stack-unit and the configuration is applied
to all the stack-units present in the PE.
Enter the keyword rpm to disable auto-reboot of the failed RPM.
Description
Introduced on the C9010.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the all option.
Introduced on the E-Series ExaScale.
Introduced on the E-Series
High Availability (HA) 910