Default Vlan-Id - Dell C9000 Series Reference Manual

Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface
may continually switch between Master and Backup.
NOTE: For more information, refer to
portmode hybrid in the

default vlan-id

Specify a VLAN as the Default VLAN.
C9000 Series
Syntax
default vlan-id vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the no
default vlan-id vlan-id syntax.
Parameters
vlan-id
Defaults The Default VLAN is VLAN 1.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
VLAN Stacking
Interfaces chapter.
Enter the VLAN ID number of the VLAN to become the new
Default VLAN. The range is from 1 to 4094. The default is 1.
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
and VLAN-related commands, such as
Layer 2 1328