Network Area - Dell C9000 Series Reference Manual

Parameters
number
Defaults 4
Command Modes ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command History
This guide is platform-specific. For command information about other platforms, see
relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.1(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.6.1.0
7.5.1.0
6.1.1.1

network area

Define which interfaces run OSPF and the OSPF area for those interfaces.
C9000 Series
Syntax
network ip-address mask area area-id
To disable an OSPF area, use the no network ip-address mask area area-id
command.
Parameters
ip-address
Specify the number of paths. The range for OSPFv2 is from 1 to
64. The default for OSPFv2 is 4 paths. The range for OSPFv3 is
from 1 to 64. The default for OSPFv3 is 8 paths.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced support for OSPFv3 on the S4810 and Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for Multi-Process OSPF.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Specify a primary or secondary address in dotted decimal
format. The primary address is required before adding the
secondary address.
Open Shortest Path First (OSPFv2 and OSPFv3) 1516