Line
Output Statistics:
Rate information...
Time since...
Example
Dell# show interfaces
TenGigabitEthernet 2/0 is down, line protocol is down
Hardware is DellForce10Eth, address is 74:86:7a:ff:6f:18
Pluggable media present, Media type is unknown
Interface index is 151060994
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed 10000 Mbit
Flowcontrol rx on tx off
Description
•
Number of runts, giants, and throttles packets:
•
Number of CRC, overrun, and discarded packets:
Displays output statistics sent out of the interface including:
•
Number of packets, bytes, and underruns out of the
interface
•
Packet size and the number of those packets outbound to
the interface
•
Number of Multicast, Broadcast, and Unicast packets:
•
Number of VLANs, throttles, discards, and collisions::
Estimate of the input and output traffic rate over a designated
interval (30 to 299 seconds). Traffic rate is displayed in bits,
packets per second, and percent of line rate.
Elapsed time since the last interface status change (hh:mm:ss
format).
Current address is 74:86:7a:ff:6f:18
Wavelength is 0.00nm
•
Broadcasts = number of MAC broadcast packets
•
runts = number of packets that are less than 64B
•
giants = packets that are greater than the MTU size
•
throttles = packets containing PAUSE frames
•
CRC = packets with CRC/FCS errors
•
overrun = number of packets discarded due to FIFO
overrun conditions
•
discarded = the sum of runts, giants, CRC, and
overrun packets discarded without any processing
•
Multicasts = number of MAC multicast packets
•
Broadcasts = number of MAC broadcast packets
•
Unicasts = number of MAC unicast packets
•
Vlans = number of VLAN tagged packets
•
throttles = packets containing PAUSE frames
•
discarded = number of packets discarded without any
processing
•
collisions = number of packet collisions
•
wred=count both packets discarded in the MAC and
in the hardware-based queues
Interfaces
960