Service-Class Bandwidth-Percentage - Dell C9000 Series Reference Manual

CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
Usage Information By default, when rate policing and shaping, the system does not include the Preamble,
SFD, or the IFG fields. These fields are overhead; only the fields from MAC destination
address to the CRC are used for forwarding and are included in these rate metering
calculations.
Use this command in Configuration Terminal Batch mode to enable the QoS rate
adjustment in a dual-homing setup.

service-class bandwidth-percentage

Specify a minimum bandwidth for queues.
C9000 Series
Syntax
service-class bandwidth-percentage queue0 percentage queue1
percentage queue2 percentage queue3 percentagequeue4 percentage
queue5 percentage queue6 percentage
Parameters
percentage
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced.
Enter the bandwidth-weight as a percentage. The range is from
1 to 100.
Quality of Service (QoS) 1786