Dell C9000 Series Reference Manual page 1220

Parameters
interface
linecard slot-id
brief
configured
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
8.1.1.2
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Loopback interface, enter the keyword Loopback
then a number from 0 to 16383.
• For the Management interface, enter the keyword
ManagementEthernet then zero (0).
• For the Null interface, enter the keyword null then zero
(0).
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a tunnel interface, enter the keyword tunnel then the
tunnel interface number. The range is from 1 to 16383.
• For a VLAN, enter the keyword vlan then a number from 1
to 4094.
Enter the linecard slot-id parameters to specify the switch
ports on a line card. The range of slot IDs is from 0 to 2.
(OPTIONAL) Enter the keyword brief to view a brief summary
of the interfaces and whether an IP address is assigned.
(OPTIONAL) Enter the keyword configured to display the
physical interfaces with non-default configurations only.
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on ExaScale.
Introduced on the S4810.
Supported on the E-Series ExaScale E600i.
IPv4 Routing 1220