Service-Class Dot1P-Mapping - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.1
8.2.1.0
Usage Information Guarantee a minimum bandwidth to different queues globally using the service-
class bandwidth-percentage command from CONFIGURATION mode. The
command is applied in the same way as the bandwidth-percentage command in an
output QoS policy. The bandwidth-percentage command in QOS-POLICY-OUT
mode supersedes the service-class bandwidth-percentage command.
Use this command in Configuration Terminal Batch mode to specify the minimum
bandwidth for queues in a dual-homing setup.

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.
C9000 Series
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value | dot1p2
value | dot1p3 value | dot1p4 value| dot1p5 value | dot1p6 value |
dot1p7 value}
Parameters
dot1p0 value ...
dot1p7 value
Defaults For each dot1p Priority, the default CoS queue value is:
Description
Introduced the Configuration Terminal Batch mode on C9010.
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 7.
• Dot1p Priority: 0 1 2 3 4 5 6 7
• Queue: 1 0 2 3 4 5 6 7
Quality of Service (QoS) 1787