Show Ipv6 Neighbors - Dell C9000 Series Reference Manual

Example
Dell(conf)#ipv6 nd ra-guard policy test
Dell(conf-ra_guard_policy_list)#show config
!
ipv6 nd ra-guard policy test
device-role router
hop-limit maximum 251
mtu 1350
other-config-flag on
reachable-time 540
retrans-timer 101
router-preference maximum medium
trusted-port
Dell(conf-ra_guard_policy_list)#
Related
Commands

show ipv6 neighbors

Display information about the IPv6 neighbors discovered on the switch CPUs.
C9000 Series
Syntax
show ipv6 neighbors [cpu rp] [ipv6–address] {ipv6–address}]
[interface interface [vrf vrf-name]
Parameters
vrf vrf-name
cpu rp
ipv6–address
• device-role — Specifies the role of the device attached to the port.
• hop-limit — Enables the verification of the advertised hop count limit.
• mtu — Sets the maximum transmission unit (MTU) value.
• other-config-flag — Enables the verification of the advertised other configuration
parameter.
• reachable-time — Sets the advertised reachability time.
• retrans-timer — Sets the advertised retransmission time.
• router-preference maximum
router preference (DRP) value.
(OPTIONAL) Enter the keyword vrf followed by the name of the
VRF to display the neighbors corresponding to that VRF.
Enter the keywords cpu rp to display information about IPv6
neighbors learned only on the Route Processor.
Enter the IPv6 address of a neighbor to display information
about the specified device.
— Enables the verification of the advertised default
NOTE: If you do not specify this option, neighbors
corresponding to the default VRF are displayed.
Neighbor Discovery Protocol (NDP) 1454