Offline - Dell C9000 Series Reference Manual

offline

Place the PE stack-unit in the offline state to run the diagnostics tests.
C9000 Series
Syntax
offline stack-unit unit-number
Parameters
stack-unit slot-id
Defaults none
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Information Use this command to make the port extender offline and run offline diagnostics tests.
After this command is issued, a warning message appears cautioning you about
bringing down all the protocols and turning down the PE unit operationally during the
diagnostics tests. If offline diagnostics are not run after issuing the offline stack-
unit command, you must issue the online stack-unit command to bring up the
PE stack-unit.
Dell#offline stack-unit 3
Warning - offline of unit will bring down all the protocols and
the unit will be operationally down, except for running
Diagnostics. Please make sure that stacking is not configured for
Diagnostics execution. If configured, the unit roles may change.
The unit will become standalone once diags are executed. Also
reboot/online command is necessary for normal operation after the
offline command is issued. Proceed with Offline [confirm yes/no]:
Related
Commands
Enter the keyword stack-unit and specify the stack-unit
number. The stack-unit number range is from 0 to 7.
Description
Introduced on the C9010 and C1048P.
• diag — run diagnostic tests on an offline switch.
• online–brings a PE stack-unit back online after running offline diagnostic tests.
PE Console Commands 1615