Dell C9000 Series Reference Manual page 1701

Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.5(0.1)
9.4(0.0)
8.4.2.1
8.4.2.0
7.7.1.0
Usage Information You can apply any number of redirect-groups to an interface. A redirect list can contain
any number of configured rules. These rules include the next-hop IP address where the
incoming traffic is redirected.
If the next hop address is reachable, traffic is forwarded to the specified next hop.
Otherwise, the normal routing table is used to forward traffic. When a redirect-group is
applied to an interface and the next-hop is reachable, the rules are added into the PBR
CAM region. When incoming traffic hits an entry in the CAM, the traffic is redirected to
the corresponding next-hop IP address specified in the rule.
Related
•
Commands
•
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048–ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4810, S4820T, S6000, and Z9000.
Introduced on the C-Series and S-Series.
Introduced on the E-Series TeraScale.
Introduced on the E-Series ExaScale.
NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.
show cam pbr – displays the content of the PBR CAM.
show ip redirect-list – displays the redirect-list configuration.
Policy-based Routing (PBR) 1701