Tagged - Dell C9000 Series Reference Manual

1/81)
Related
interface vlan
Commands

tagged

Add a Layer 2 interface to a VLAN as a tagged interface.
C9000 Series
Syntax
tagged interface
To remove a tagged interface from a VLAN, use the no tagged interface
command.
Parameters
interface
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
— configures a VLAN.
Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
Description
Introduced on the C9010.
Introduced on the Z9500.
T Po20(Te
T Fo 2/0
Layer 2 1335