Ipv6 Address Autoconfig - Dell C9000 Series Reference Manual

interface TenGigabitEthernet 1/0
Dell(conf-if-te-1/0)#

ipv6 address autoconfig

Configure IPv6 address auto-configuration for the management interface.
C9000 Series
Syntax
ipv6 address autoconfig
To disable the address autoconfig operation on the management interface, use the no
ipv6 address autoconfig command.
Default Disabled
Command Modes INTERFACE (management interface only)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.1)
9.1.(0.0)
8.3.19.0
8.3.12.0
Usage Infomation
no ip address
ipv6 address 2002:1:2::3 /96
no shutdown
Description
Introduced on the C9010.
Introduced on the S3048-ON.
Introduced on the S4048-ON.
Updated Usage Information section.
Introduced on the S4820T.
Introduced on the S4810.
• SAA can configure up to two addresses. If any preferred prefix or valid timers time
out, the corresponding address are deprecated or removed. If an address is
removed due to a time-out, an address from the current unused prefix is used to
create a new address. If there are no remaining prefixes, the software waits to
receive a new prefix from the RA.
• If auto-configuration is enabled, all IPv6 addresses on that management interface
are auto-configured. Manual and auto-configurations are not supported on a
single management interface.
IPv6 Basics 1271