Show Interfaces Dampening - Dell C9000 Series Reference Manual

rate
line-rate
Time since last interface status change: 00:55:34
Related show interfaces
Commands interface.

show interfaces dampening

Display interface dampening information.
C9000 Series
Syntax
show interfaces dampening [[interface] [summary] [detail]]
Parameters
interface
summary
detail
Defaults none
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
Output 00.00 Mbits/sec,
— displays information on a specific physical interface or virtual
(Optional) Enter one of the following keywords and slot/port or
number information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a port extender Gigabit Ethernet interface, enter the
keyword peGigE then the pe-id / stack-unit / port-id
information. The pe-id range is from 0 to 255; the stack-
unit unit-number range is from 0 to 7; and the port-id
range is from 1 to 48.
NOTE:
feature extended bridge feature is enabled.
(OPTIONAL) Enter the keyword summary to display the current
summary of dampening data, including the number of interfaces
configured and the number of interfaces suppressed, if any.
(OPTIONAL) Enter the keyword detail to display detailed
interface dampening data.
0 packets/sec, 0.00% of
The peGigE output is only visible when the
Interfaces 976