Interface - Dell C9000 Series Reference Manual

Example
Dell(conf-if-te-0/1)# show config
!
interface TengigabitEthernet 0/1
no ip address
switchport
no negotiation auto
flowcontrol rx off tx on
no shutdown
...
Related
Commands

interface

Configure a physical or logical interfaces on the switch.
C9000 Series
Syntax
interface interface range [group interface]
Parameters
interface
• Half duplex cannot be configured when the flow control configuration is on
(default is rx on tx on). The following error is returned:
Can't configure half duplex when flowcontrol is on, config
ignored
NOTE: The flow control must be off (rx off tx off) before configuring the
half duplex.
NOTE: If you use the disable rx flow control command, Dell Networking
recommends rebooting the system.
NOTE: The flow control feature is not supported on the Port Extender Gigabit
Ethernet (peGigE) interface.
• show running-config
values only).
• show interfaces — displays the negotiated flow control parameters.
Enter one of the following keywords and slot/port, pe-id /stack-
unit or number information:
•
•
•
•
— displays the flow configuration parameters (non-default
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet then the slot/port information.
For a Loopback interface, enter the keyword loopback
then the slot/port information. The range is from 0 to
16383.
For a Management Ethernet interface, enter the keyword
managementethernet then the slot/port information.
Interfaces 931