Ipv6 Ospf Cost - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.2(1.0)
9.2.0.0
Usage Information This command provides the flexibility to fine-tune the timer values based on individual
interface needs when you configure ipv6 ospf BFD in CONFIGURATION mode. Any
timer values specified with this command overrides timers set using the bfd all-
neighbors command. Using the no form of this command does not disable BFD if you
configure BFD in CONFIGURATION mode.
To disable BFD on a specific interface while you configure BFD in CONFIGURATION
mode, use the keyword disable.

ipv6 ospf cost

Explicitly specify the cost of sending a packet on an interface.
C9000 Series
Syntax
ipv6 ospf interface-cost
Parameters
interface-cost
Defaults Default cost based on the bandwidth.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
9.1.(0.0)
7.8.1.0
7.4.1.0
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000, S4820T, and S4810.
Enter a unsigned integer value expressed as the link-state
metric. The range is from 1 to 65535.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4810 and Z9000.
Added support for C-Series.
Introduced on the E-Series.
Open Shortest Path First (OSPFv2 and OSPFv3) 1585