Show Ip Pim Ssm-Range - Dell C9000 Series Reference Manual

Version
8.1.1.0
7.8.1.0
7.7.1.0
7.5.1.0
Usage Information Dell Networking OS supports standard access lists for the SSM range. You cannot use
extended ACLs for configuring the SSM range. If you configure an extended ACL and
then used in the ip pim ssm-range {access list name} configuration, an error
is reported.
However, if you configure ip pim ssm-range {access list name} first and then
you configure the ACL as an Extended ACL, an error is not reported and the ACL is not
applied to the SSM range.
Dell Networking OS-recommended best-practices are to configure the standard ACL,
and then apply the ACL to the SSM range. After the SSM range is applied, the changes
are applied internally without requiring clearing of the tree information base (TIB).
When the ACL rules change, the ACL and protocol-independent multicast (PIM)
modules apply the new rules automatically.
When you configure the SSM range, Dell Networking OS supports SSM for configured
group range as well as the default SSM range.
When you remove the SSM ACL, PIM SSM is supported for the default SSM range only.

show ip pim ssm-range

Display the non-default groups added using the SSM range feature.
C9000 Series
Syntax
show ip pim ssm-range
Defaults none
Command Modes
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the E-Series ExaScale.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
• EXEC
• EXEC Privilege
PIM-Source Specific Mode (PIM-SSM) 1668