Dell C9000 Series Reference Manual page 1638

elected standby. To change the default master and standby assignment, you can assign
stack-unitpriority value. If multiple units tie for the highest priority, the unit with
the highest MAC address is elected master.
In the following example, stack-unit 0 with priority 14 is the master and stack-unit 1
with priority 13 is the standby.
Example (stack-
Dell(conf)#pe 2
unit priority)
Dell(conf-pe-2)#stack-unit 0 priority 14
Dell(conf-pe-2)#stack-unit 1 priority 13
Example (stack
Dell(conf-pe-5)#stack-unit 4 type C1048P
unit type)
Dell(conf-pe-5)# show config
!
pe provision 5
stack-unit 4 type C1048P
Related
•
Commands
•
NOTE: You can configure a stack-unit priority only when the unit is online.
redundancy force-failover
master unit
reset — Reset or reboot the linecard, RPM, PE and PE stack-unit.
— Force the standby unit to become the primary or
PE Stacking 1638