Ipv6 Control-Plane Egress-Filter - Dell C9000 Series Reference Manual

Version
9.2(1.0)
8.3.19.0
8.3.7.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
specification on entries allowed per ACL, refer to your line card documentation.
Use this command in Configuration Terminal Batch mode to configure the access list in
a dual-homing setup.
Related show config
Commands

ipv6 control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
C9000 Series
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command Modes
EXEC Privilege
CONFIGURATION TERMINAL BATCH
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
Description
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series ExaScale.
Introduced on the C-Series. Increased the name string to accept
up to 140 characters. Prior to version 7.8.1.0, names are up to 16
characters long.
Introduced on the E-Series TeraScale.
— views the current configuration.
Description
Introduced the Configuration Terminal Batch mode on C9010.
IPv6 Access Control Lists (IPv6 ACLs) 1252