Fefd Disable - Dell C9000 Series Reference Manual

Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.12.0
Usage Information When you enter no fefd for an interface and fefd-global, FEFD is enabled on the
interface because the no fefd command is not retained in the configuration file. To
keep the interface FEFD disabled when the global configuration changes, use the fefd
reset command.
Related
Commands

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
C9000 Series
Syntax
fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
• fefd disable — disables far-end failure detection on an interface.
• fefd reset — enables FEFD globally on the system.
• fefd mode — changes FEFD mode on an interface.
Description
Introduced on the C9010.
Layer 2 1341