Track Interface Ip Routing - Dell C9000 Series Reference Manual

track interface ip routing

Configure object tracking on the routing status of an IPv4 Layer 3 interface.
C9000 Series
Syntax
track object-id interface interface ip routing
To return to the default setting, use the no track object-id command.
Parameters
object-id
interface
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
8.3.12.0
8.4.1.0
Usage Information Use this command to create an object that tracks the routing state of an IPv4 Layer 3
interface:
Enter the ID number of the tracked object. The range is from 1
to 500.
Enter one of the following values:
• For a 1-Gigabit Ethernet interface, enter
gigabitethernet and the slot-number/ port-number.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a port channel interface, enter the keywords port-
channel then a number.
• For a 10-Gigabit Ethernet interface, enter
tengigabitethernet and the slot-number/ port-
number.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S4810.
Introduced.
Object Tracking 1466