Dell C9000 Series Reference Manual page 1455

ipv6-address
interface interface
Defaults none
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.8(0.0)
9.7(0.0)
9.2(1.0)
9.0.0.0
8.3.19.0
8.3.11.1
8.3.7.1
Usage Information When you issue the show ipv6 neighbors without specifying any options, it will
display all IPv6 neighbor addresses stored on the control processor (CP).
Example
Dell#show ipv6 neighbors
*
Ad Dn - Admin Down
B
C
I
O
R
Clients
* 10.1.3.2
Dell#show ipv6 neighbors detail
Session Discriminator: 1
Neighbor Discriminator: 1
Enter the IPv6 address of the neighbor in the x:x:x:x::x format.
Enter the keyword interface then the interface type and slot/
port or number information:
EXEC
EXEC Privilege
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Added support for VRF. Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
- Active session role
- BGP
- CLI
- ISIS
- OSPF
- Static Route (RTM)
LocalAddr RemoteAddr
10.1.3.1
NOTE: The :: notation specifies successive hexadecimal
fields of zero.
Interface State Rx-int Tx-int Mult
Te 1/3 Up
Neighbor Discovery Protocol (NDP)
300 250 3 C
1455