Multiplier - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Related
protocol lldp (Configuration)
Commands
show lldp neighbors

multiplier

Set the number of consecutive misses before LLDP declares the interface dead.
C9000 Series
Syntax
multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer
Defaults 4 x hello
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— enables LLDP globally.
— displays the LLDP neighbors.
Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
Link Layer Discovery Protocol (LLDP) 1371