Deny Arp (For Extended Mac Acls) - Dell C9000 Series Reference Manual

Usage Information To stop packets from flooding the user terminal when debugging is turned on, use the
count option.
The access-group option supports only the equal to (eq) operator in TCP ACL rules.
Port operators not equal to (neq), greater than (gt), less than (lt), or range are not
supported in access-group option (refer to the following example). ARP packets (arp)
and Ether-type (ether-type) are also not supported in the access-group option.
The entire rule is skipped to compose the filter.
The access-group option pertains to:
If an ambiguous access control list rules, the debug ip packet access-control
command is disabled. A message appears identifying the error (refer to the following
Example).
Example (Error
Dell#debug ip packet access-group test
Messages)
%Error: port operator GT not supported in access-list debug
%Error: port operator LT not supported in access-list debug
%Error: port operator RANGE not supported in access-list debug
%Error: port operator NEQ not supported in access-list debug
Dell#00:10:45: %RPM0-P:CP
%IPMGR-3-DEBUG_IP_PACKET_ACL_AMBIGUOUS_EXP: Ambiguous rules not
supported in access-list debug, access-list debugging is turned
off
Dell#

deny arp (for Extended MAC ACLs)

Configure an egress filter that drops ARP packets on egress ACL supported line cards. (For more information,
refer to your line card documentation).
C9000 Series
Syntax
deny arp {destination-mac-address mac-address-mask | any} vlan
vlan-id {ip-address | any | opcode code-number} [count [byte]]
[order] [log [interval minutes] [threshold-in-msgs [count]]
[monitor]
• IP protocol number: from 0 to 255
• Internet control message protocol (icmp) but not the ICMP message type (from 0
to 255)
• Any internet protocol (ip)
• Transmission Control Protocol (tcp) but not on the rst, syn, or urg bits
• User Datagram Protocol (udp)
IPv4 Routing 1185