Use the commands in this chapter to configure and manage C1048P port-extender (PE) stacking. Stacking is
not supported on C9010 switches.
For information about using the PE stacking feature, see the "Port Extender (PE) Stacking" chapter in the Dell
Networking OS Configuration Guide for the C9000 Series.
You can use the commands to pre-configure a port extender, so that the configuration settings are invoked
when the switch is attached to the chassis.
Topics:
•
renumber
•
reset
•
show pe system
•
show hardware pe
•
stack unit
renumber
To rearrange the stack units, reassign a stack unit ID number.
C9000 Series
Syntax
pe pe-id stack-unit unit number renumber unit number
Parameters
pe pe-id
stack-unit unit
number
renumber unit
number
Default
Default stack-unit number is zero.
Command Modes
EXEC Privilege
Enter the keyword pe and the PE ID. The range is from 0 to 255.
Enter the keyword stack-unit and the stack-unit ID number.
The range is from 0 to 7.
Enter the keyword renumber and a new stack-unit ID number.
The range is from 0 to 7.
39
PE Stacking
PE Stacking
1627