Using Sftos Stacking Commands; Using Ftos Stacking Commands - Dell Force10 S50N Series Installing Manual

Using SFTOS Stacking Commands

If the switch is running SFTOS, the commands available to manage stacking are described in the
Stacking chapters of the SFTOS Command Reference and the SFTOS Configuration Guide.
You can execute
recommended in Best Practices in the Stacking chapter of the SFTOS Configuration Guide.
You can use the SFTOS CLI to make stack identification changes on the fly:
• Renumber units:
• Assign a new management unit:
• Remove a unit from stack membership:
You can also use commands such as
identification algorithms.
show switch
Use the
show switch unit
Use the
For details on and other stacking commands, see the Stacking chapter in the SFTOS Configuration Guide
and the Stacking Commands chapter in the SFTOS Command Reference.

Using FTOS Stacking Commands

If the switch is running FTOS, the following commands are available to manage stacking:
stack-unit unit priority 1-14
• Use the
the management unit of a stack.
stack-unit unit provision
• Use the
stacking ID of a switch that will join the stack. This is an optional command that is executed on the
management unit.
stack-unit unit renumber unit
• Use the
member except the management unit.
show system brief
• Use the
show system stack-unit unit
• Use the
other system details.
show system stack-ports
• Use the
For details on using FTOS to remove a unit from a stack or use other stacking commands, see the
Stacking Commands chapter in the FTOS Command Reference and the S-Series Stacking chapter in the
FTOS Configuration Guide.
24 | Installing the Switch
clear config
on the switch to start a clean configuration. Then pre-configure it, as
switch renumber
movemanagement
switch priority
command to see the current assignment of the management unit.
command to see the serial number of the designated unit.
S25N
{
command to see the current assignment of the management unit.
command to see the stacking topology and status.
no member
member
and
command to configure the ability of an S-Series switch to become
S25P S25V S50N S50V
| | | |
command to renumber a standalone S-Series or any stack
command to see the serial number of the designated unit and
that override the default unit
} command to pre-configure a