Set As-Path - Dell S4810 Reference Manual

Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage Use caution when you delete route maps because if you do not specify a sequence
Information number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
Related show config
Commands

set as-path

To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
S4810
Syntax
set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number
| tag} command.
Parameters
prepend as-
number
Defaults Not configured.
Command ROUTE-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
284
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the current configuration.
Enter the keyword prepend and then enter up to eight AS
numbers to be inserted into the BGP path information. The
range is from 1 to 65535.
Introduced on the S6000.
Introduced on the S4820T.
Access Control Lists (ACL)