Set As-Path - Dell S4810 Reference Manual

Defaults Not configured.
If you do not define a keyword (permit or deny) for the route map, the permit
action is the default.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.1.1.0
Version 7.8.1.0
Version 7.6.1.0
Version 7.5.1.0
pre-Version
6.1.1.0
Usage Use caution when you delete route maps because if you do not specify a sequence
Information number, all route maps with the same map-name are deleted when you use the no
route-map map-name command.
Example
Dell(conf)#route-map dempsey
Dell(config-route-map)#
Related show config
Commands

set as-path

To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
S4810
Syntax
set as-path prepend as-number [... as-number]
282
prompted for a sequence number if there are multiple
instances of the route map. The range is from 1 to 65535.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series ExaScale.
Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names are up to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
— displays the current configuration.
Access Control Lists (ACL)