Table of Contents
Advertisement
Verification Testing with the SC2080KE Device
Initial System Verification Test Setup
Configure Common Settings
Click the Settings icon at the top of the screen.
Click Global Settings > Output Directory: Select the directory (folder) on the host PC
to which the DPT characterization data gets saved. There is no default path or
folder; you must specify the path.
Hardware Configuration Hardware Tab
Select Settings > Hardware Configuration for Double-Pulse Measurement Control tab.
1 Set and Verify Hardware Configuration.
1. Enter the
oscilloscope's
IP Address
Figure 15 PD1500A Hardware Configuration Screen
Keysight PD500A Double-Pulse Test System Installation Guide
a Select Settings > Hardware Configuration for Double-Pulse Measurement Control
tab. This opens the following Hardware Configuration screen.
b Refer to the PD1500A Control Software Guide for detailed information
about the PD1500A Hardware Configuration.
PD1500A System Verification
Check
2. Click the
Button to verify
communication
with test
instruments.
79
Advertisement
Table of Contents
